These are 2 turned solid aluminum Yoda sabers. The parts are mainly made out of aluminum, other than the control box and the black leather grips. The emitter fin is made out of 22 gauge steel. The smaller one on the left is the same dimensions as the MR version and the larger one on the right is the same dimensions as the new Yoda FX saber. I also tapped a 1/2in hole in the emitter and have a threaded aluminum rod in it.
This Yoda saber is made out of solid surface material actually holds a threaded acrylic blade which I sell on the parts page..
An M.R. Yoda saber. They actually have 2 green stones in them now.
Larbel Qui Gon saber on left and MR on right
This was my 11 inch chrome plated steel Qui Gon Jinn saber. The sleeve can be removed by removing the Covertec wheel and by unscrewing the end cap.
This is my first solid turned aluminum Qui Gon Jinn saber. It breaks down into pieces and has a chrome plated sleeve.
My Mace Windu
This Windu saber is made out of solid turned material, leather and rubber grips and various metal pieces.
I redid the above saber and it now has aluminum parts on it. The gold top emitter piece with the holes in it is aluminum as well as the mid section of 4 gold rings and the entire end piece after the rubber grips!
My new Windu "all solid turned aluminum" saber!
With Brass parts I made.
M.R. Mace Windu saber
I made leather gripping material similiar to the M.R. pattern.
My other creations, parts and links 4 - 5 - 6
Next Previous Home Page